I am testing the Xlinx JESD204-IP for interfacing the AFE7950EVM. My evaluation board is zcu102 and I connect afe7950evm to the HPC1 of zcu102. I am trying to use 8b/10b in the mode of subclass 1. I ...

I am using an ADS131A02 and an ESP32-PICO-KIT for my project. In this case, the ADS131A02 is in synchronous slave interface mode, as I will be using SCLK as iCLK. The problem is that I cannot get a ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

* @note This function is empty by default. * This function is called after startup. * The user can use this function to implement the application.

I hope this message finds you well. We are currently utilizing Texas Instruments' mmWave radar in various radar systems and are now focused on the development of an in-cabin radar system. To expedite ...

Can you please provide some guidance regarding the PCB Layout mentioned on page 36 of the THS4561’s data sheet. I am using the WQFN 10 pin package (the diagram on page 36 only shows the layout for the ...

C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

hex文件中用到0x8000的地址，应该是跟section的定义有关，如在cmd文件中配置为.TI.ramfunc，而实际移植程序时未修改，在ram中运行的地方还是用的ramfuncs。而通过hex2000转换告警的问题，还是没有定位 ...

Try to updated SBL at default location at 0x0 in OSPI flash. And, we have backup image at 0x40_0000 on OSPI as fall back SBL. If update at 0x0 is failed or not properly done. AM243x might have fall ...

Check the generated file test.json, the 0x34, 0x38, 0x3C are configured to select PDM1 PDM1 and echo as channel0, channel1 channel2 in the I2S/TDM commnuication. 6. Copy the test.bin to the kernel and ...

Kindly review the schematic of BQ2980 along with fuel guage IC BQ27Z561fuel guage IC and TPS2121 power path IC. I am bit confused regarding GND connectionSCH_Schematic1_3-PowerSection_2024-09-18.pdf ...

I'd like to connect to the TMS320F280037 with XDS200 Debug Probes while my program is running without flashing new code and without halting the operation. From reading other posts, I have tried the ...